DOI:
https://doi.org/10.69717/jaest.v2.i1.31Keywords:
Retaining wall, Frictional soil, Seismic earth pressure, Finite element, PLAXISAbstract
The seismic earth pressures with presence of water, acting against a vertical retainingwall are often a function of many parameters. In the case of saturated sands, the earthquakecauses failure of the retaining wall resulting by soil liquefaction. The theoretical methods for thecalculation of seismic earth pressures available in literature remain unable to solve the envisagedproblems. In this study the finite element code PLAXIS is used to evaluate the active earth pressureacting against a vertical rigid retaining wall. The soil is modeled by an elasto-plastic model with aMohr-Coulomb yield criterion. In this study, several parameters have been considered in order toevaluate the effect of soil acceleration with transitory flow and hydrostatic groundwater. Theresults have been compared with those obtained by the pseudo-dynamic and pseudo-staticapproaches. The results show the influence of the seismic action on the earth pressures.
Downloads
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Most read articles by the same author(s)
- Oussama Temami, Djamal Hamadi, Abdallah Zatar, Ashraf Ayoub, Experimental and numerical analyses of a thin cylindrical shell model , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
- Salima Rezig, Ahmed Bouaziz, Abdallah Zatar, Experimental investigation on the optimal formulation of dune sand concrete reinforced with date palm fibers , Journal of Applied Engineering Science & Technology: Vol. 3 No. 1 (2017): JAEST
- Ouassim Rahmouni, Abdelhak Mabrouki, Djamel Benmeddour, Mekki Mellas, Numerical study of geogrid-reinforced segmental earth retaining wall , Journal of Applied Engineering Science & Technology: Vol. 1 No. 2 (2015): JAEST
- Salah Zerguine, Djamel Benmeddour, Abdelhak Mabrouki, Bearing capacity of a strip footing on a geosynthetic reinforced soil modular block walls after a seismic loading , Journal of Applied Engineering Science & Technology: Vol. 4 No. 1 (2018): JAEST
- Mohamed‐Younes Ouahab, Abdelhak Mabrouki, Mekki Mellas, Djamel Benmeddour, Numerical study of the bearing capacity for strip and circular footings on non‐ homogeneous clay , Journal of Applied Engineering Science & Technology: Vol. 3 No. 1 (2017): JAEST
Similar Articles
- Roger Frank, Eurocode 7 on ‘Geotechnical design’: a code for soil-structure interaction , Journal of Applied Engineering Science & Technology: Vol. 1 No. 1 (2014): JAEST
- Oussama Temami, Djamal Hamadi, Abdallah Zatar, Ashraf Ayoub, Experimental and numerical analyses of a thin cylindrical shell model , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
- Abla Femmam, Abdelhak Mabrouki, Mekki Mellas, Numerical study of the bearing capacity of a strip footing on tow layered clay under inclined loading , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Sadok Benmebarek, Ahlem Guetari, Mohamed-Saddek Remadna, Effect of the eccentric load on the bearing capacity of a strip footing founded on sand , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Mohamed-Zohaïr Kaab, Abdelhafid Ounis, Influence of the combined system FPS isolator with viscous fluid damper on the dynamic response of the isolated bridges , Journal of Applied Engineering Science & Technology: Vol. 3 No. 2 (2017): JAEST
- Hadj Bekki, Behavior of Soil-structure interfaces under cyclic loading for large numbers of cycles: Application to piles , Journal of Applied Engineering Science & Technology: Vol. 1 No. 1 (2014): JAEST
- Ouassila Bahloul, Khelifa Abbeche, Azeddine Bahloul, Study of the microstructure of collapsible soil treated with the potassium chloride , Journal of Applied Engineering Science & Technology: Vol. 2 No. 1 (2016): JAEST
- Hadj Bekki, Brahim Tali, Jean Canou, Jean-Claude Dupla, Ali Bouafia, Influence of the cyclic loading of very large number of cycles on the pile capacity , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
- Salah Messast, Numerical modeling of the face reinforcement of Djebel El-Kantour tunnel face (highway east-west) , Journal of Applied Engineering Science & Technology: Vol. 1 No. 1 (2014): JAEST
- Islam-Ncereddine El Ghoul, Ahmed Cheriet, Samir Bensaid, Ala-Eddine Lakhdari, FVM model and virtual instrument based system for electromagnetic characterization of steel material , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
You may also start an advanced similarity search for this article.