JAEST LOGO

Authors

Hadj Bekki Université Ibn khaldoun de Tiaret, Algérie Author
Brahim Tali École Nationale des Ponts et Chaussées, Univ. Paris-Est, UR Navier, CERMES, France Author
Jean Canou École Nationale des Ponts et Chaussées, Univ. Paris-Est, UR Navier, CERMES, France Author
Jean-Claude Dupla École Nationale des Ponts et Chaussées, Univ. Paris-Est, UR Navier, CERMES, France Author
Ali Bouafia Université Saâd Dahleb de Blida, Algérie Author

DOI:

https://doi.org/10.69717/jaest.v2.i2.40

Keywords:

Calibration chamber, Pile model, Soil, Interface, Bearing capacity, Cyclic loading

Abstract

The paper presents a study of the bearing capacity of a pile model in calibrationchamber, under a cyclic axial loading, up to very large number of cycles. The experimental study isaimed to the evolution of the bearing capacity of pile obtained after a cyclic loading up to 105cycles. Firstly, we present briefly the experimental device and then the results of cyclic testsperformed on the pile model in the calibration chamber. Several parameters which have asignificant influence on the cyclic behavior of piles have been investigated, such as the cyclicdisplacement amplitude and the density of the soil. The analysis of results indicated that themechanism of densification of the soil around the pile leads to improve pile capacity.

Downloads

Download data is not yet available.

Downloads

Published

2016-08-09

Issue

Section

Research Paper

How to Cite

Influence of the cyclic loading of very large number of cycles on the pile capacity. (2016). Journal of Applied Engineering Science & Technology, 2(2), 11. https://doi.org/10.69717/jaest.v2.i2.40

Similar Articles

1-10 of 33

You may also start an advanced similarity search for this article.