DOI:
https://doi.org/10.69717/jaest.v2.i1.29Keywords:
Plate anchor, Pullout capacity, Finite element, Frictional soilAbstract
This paper presents a numerical study of the ultimate pullout capacity of an isolated stripplate anchor, using the finite element method by Plaxis 2D software. The plate anchor is assumedrigid horizontally installed in a frictional soil and subjected to a centered vertical load. The soilbehavior is governed by an elastic‐perfectly plastic law, and Mohr‐Coulomb criterion was adopted.The ultimate pullout capacity is expressed in terms of pullout factor Nγ for different values of thedepth H and the internal friction angle of soil φ'. The numerical results obtained allow us topropose a simple relationship to calculate the pullout factor of a strip plate anchor embeddedhorizontally in frictional soil. The numerical results of this study are finally compared to thoseavailable in the literature.
Downloads
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
Most read articles by the same author(s)
- Hassiba Belaribi, Mekki Mellas, Using mathematical models and artificial neural networks for predicting the compressive strength of concrete with steel fibers exposed to high temperatures , Journal of Applied Engineering Science & Technology: Vol. 4 No. 1 (2018): JAEST
- Ahmed Bensalem, Mekki Mellas, Valorization of Vase Dam by the addition of the cement kiln Dust (CKD , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Issam Abdesslam, Mekki Mellas, Pushover analysis of the reinforced concrete frames with soft first storey using a fiber hinge model , Journal of Applied Engineering Science & Technology: Vol. 3 No. 2 (2017): JAEST
- Abla Femmam, Abdelhak Mabrouki, Mekki Mellas, Numerical study of the bearing capacity of a strip footing on tow layered clay under inclined loading , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Ouassim Rahmouni, Abdelhak Mabrouki, Djamel Benmeddour, Mekki Mellas, Numerical study of geogrid-reinforced segmental earth retaining wall , Journal of Applied Engineering Science & Technology: Vol. 1 No. 2 (2015): JAEST
- Mohamed Labed, Mekki Mellas, Stability of geosynthetic reinforced embankments over stone column‐improved soft soil , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
- Salah Zerguine, Djamel Benmeddour, Abdelhak Mabrouki, Bearing capacity of a strip footing on a geosynthetic reinforced soil modular block walls after a seismic loading , Journal of Applied Engineering Science & Technology: Vol. 4 No. 1 (2018): JAEST
- Mohamed‐Younes Ouahab, Abdelhak Mabrouki, Mekki Mellas, Djamel Benmeddour, Numerical study of the bearing capacity for strip and circular footings on non‐ homogeneous clay , Journal of Applied Engineering Science & Technology: Vol. 3 No. 1 (2017): JAEST
Similar Articles
- Salah Zerguine, Djamel Benmeddour, Abdallah Zatar, Numerical study of seismic earth pressures acting against a vertical retaining wall in frictional soil , Journal of Applied Engineering Science & Technology: Vol. 2 No. 1 (2016): JAEST
- Houdayfa Ounis, Mohamed-Ouejdi Belarbi, On the thermal buckling behaviour of laminated composite plates with cut-outs , Journal of Applied Engineering Science & Technology: Vol. 3 No. 2 (2017): JAEST
- Mohamed Baheddi, Youcef Youb, Study of the behavior of bridges under seismic loads considering soil-structure interaction , Journal of Applied Engineering Science & Technology: Vol. 1 No. 2 (2015): JAEST
- Abla Femmam, Abdelhak Mabrouki, Mekki Mellas, Numerical study of the bearing capacity of a strip footing on tow layered clay under inclined loading , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Sadok Benmebarek, Ahlem Guetari, Mohamed-Saddek Remadna, Effect of the eccentric load on the bearing capacity of a strip footing founded on sand , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Hamza Djeffal, Mohamed Nadir Amrane, Numerical modeling of the prestressing losses in prestressed concrete beams by modal analysis method , Journal of Applied Engineering Science & Technology: Vol. 4 No. 2 (2018): JAEST
- Hadj Bekki, Brahim Tali, Jean Canou, Jean-Claude Dupla, Ali Bouafia, Influence of the cyclic loading of very large number of cycles on the pile capacity , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
- Salah Zerguine, Djamel Benmeddour, Abdelhak Mabrouki, Bearing capacity of a strip footing on a geosynthetic reinforced soil modular block walls after a seismic loading , Journal of Applied Engineering Science & Technology: Vol. 4 No. 1 (2018): JAEST
- Hadj Bekki, Behavior of Soil-structure interfaces under cyclic loading for large numbers of cycles: Application to piles , Journal of Applied Engineering Science & Technology: Vol. 1 No. 1 (2014): JAEST
- Mohamed Labed, Mekki Mellas, Stability of geosynthetic reinforced embankments over stone column‐improved soft soil , Journal of Applied Engineering Science & Technology: Vol. 2 No. 2 (2016): JAEST
You may also start an advanced similarity search for this article.