Influence of the cyclic loading of very large number of cycles on the pile capacity
View 432/
235
DOI:
https://doi.org/10.69717/jaest.v2.i2.40Keywords:
Calibration chamber, Pile model, Soil, Interface, Bearing capacity, Cyclic loadingAbstract
The paper presents a study of the bearing capacity of a pile model in calibrationchamber, under a cyclic axial loading, up to very large number of cycles. The experimental study isaimed to the evolution of the bearing capacity of pile obtained after a cyclic loading up to 105cycles. Firstly, we present briefly the experimental device and then the results of cyclic testsperformed on the pile model in the calibration chamber. Several parameters which have asignificant influence on the cyclic behavior of piles have been investigated, such as the cyclicdisplacement amplitude and the density of the soil. The analysis of results indicated that themechanism of densification of the soil around the pile leads to improve pile capacity.
Downloads
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
This journal provides immediate open access to its content on the principle that making research freely available to the public supports a greater global exchange of knowledge.
All articles are published under the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are properly credited.
License URL: https://creativecommons.org/licenses/by/4.0/
